Control Panel SMART EVO – Introduction

Control Panel SMART EVO is the most advanced control panel for pumping and sewage systems.
GENERAL CHARACTERISTICS:

  • Power supply 1 phase 100-240Vac 50 / 60Hz;
  • Power supply 3 phase 310-450Vac 50/60Hz;
  • Input for 3 single-pole probes (COM-MIN-MAX);
  • Input G.A. normally open for alarm activation;
  • Buttons for selecting the operation
  • AUTOMATIC-0-MANUAL (temporary);
  • DIP SWITCH voter for:
    Activation alarm of probes;
    Delay of activation of thermal shutdown 5/10 seconds;
    Alarm output settings;
    Activation of alarm reset by Motorclicson;
    Filling / emptying mode;
    Enabling the start / stop swimming function;
    Delay of activation of the electronic board on mains voltage return.
  • Green LED: Power ON / Failure or wrong phase sequence;
  • Red LED: Level alarm from probes or GA input;
  • Electronic control of maximum current due to overload with supported calibration;
  • Electronic control of minimum current through dry running with assisted calibration;
  • Automatic reset due to minimum current alarm;
  • Timer for delaying motor release on mains voltage return;
  • Protection of auxiliary circuits and motor with fuses;
  • Collective alarm output with potential-free contacts (resistance load COM-NO-NC – 5A / 250V);
  • Cumulative alarm output, live (12 Vcc / 100 mA);
  • General disconnect switch of the door lock;
  • Arrangements for operating capacitors, single-phase (not included);
  • Box in ABS, IP55;
  • Ambient temperature: -5 / + 40 ° C;
  • Relative humidity 50% at 40 ° C (free of condensate).

Shop By Department