Control Panel Elentek Drytek 220V

Control panel with microprocessor for 1 single-phase or three-phase pump with power factor control. The ideal system for protecting the pump against dry-running. Practical and versatile, DRYTEK allows save the time of installation and reduces service costs.

DRYTEK control panels are assembled in ABS thermoplastic boxes with an original Elentek design, watertight, self-extinguishing, degree of protection IP55.
The DRYTEK has a practical LCD for reading the operating and alarm states, besides led lights and set-up pushbuttons on the front panel. External controls such as pressure and float switches can be connected to the terminal inside the panel.
All the set-up, control, and use operations are done by the front panel without the need to open the control box.

GENERAL FEATURES

• Power supply 1~50/60 Hz 230V ±10%;
• Normally open contact for start;
• Pushbuttons for selecting operation and set up;
• Displaying of: volt, ampere, motor power factor (COS Ø) and alarms;
• Green led indicating motor running;
• Adjustable electronic control for motor overload;
• Motor’s control on 2 phases;
• Protection from:
  • motor overcurrent (adjustable)
  • phase failure/loss
  • min/max voltage (adjustable)
  • max current (adjustable)
  • dry running power factor (COS Ø adjustable)
• Auto-restore from protection with 4 independently settable times 0÷250 minutes;
• Auxiliaries and motor protection fuses;
• Alarm output (NC-C-NO resistive load 5A / 250V);
• Main switch interlocking door;
• Provision for run capacitor for single-phase version (not included);
• Enclosure in ABS, IP55;
• Ambient temperature: -5/+40 °C;
• Relative humidity 50% at 40 °C (not condensed).